New flat winding system

Why can this system wind the line flat ? I illustrate it as following.
The other manufacturers use it too.

New flat winding system
The new flat winding system of Cardinal 300. The red line is the ditch of the oscillating slider. The violet point is the pin of the oscillating gear. The cranked ditch makes constant oscillation.

The ordinary system
On the ordinary system, the speed is slow in the end of spool.
So, the line is not flat.
Especially, 0 to 3 and 9 to 12 are high density.

New system
9 to 12 is not slow, because the cranked ditch pushes out the slider.
0 to 3 is not slow, because it is not end of gear.
The oscillating width is wider than the ordinary system.

This is excellent !

The worm shaft system (cross gear system) needs the high quality parts, for example hard chromed shaft and nitrided pin.
It is hard to keep the quality except in Japan.
But this system does not need such parts. It can be made by zinc die-casting.

Of course, the cost is lower.
Although it makes the reel body larger, it is not so heavy because it is simple. Moreover it is better for the weight balance.

This system will finish the worm shaft spinning reels.
And it will finish " made in Japan ".
(2003/6/18)
AbuGarcia