Arrangement of the "C"
I arranged Avocet C1000.
Mitchell Avocet C1000 Although Mitchell was a expensive reel, it become a cheap one. I arranged it. |
|
Drag The drag of C1000 is not good. Its washer is too small to get enough performance. And, only the upper felt washer works as a friction washer. I changed the grease to the Shimano's ACE-2. It is the grease for the drag washers of Shimano's bait reels. It improves the drag performance. |
|
Improving the drag (2006/10/30) I tried changing the washer like this picture. The drag range was improved. Although a "key" washer and a felt washer are needed, the drag knob works as a "key" washer. The black washer is the spool washer of Shimano. |
|
Above is drag power of after change. |
|
Rotor brake Japanese spinning reels have the rotor braking system. It supports the feathering of the forefinger. But Mitchell reels don't have it. I bonded the "magic tape" as the "rotor brake"by the epoxy glue. I used the soft side and greased by the ACE-2. |
|
Bail stopper Avocet has the bail stopper on the opposite side of the bail arm. Although it is a good design, the pin of #500 and #1000 is short. So, I added the epoxy on the rotor for enough strength. |
|
Bushings for drive gear The looseness of handle is large. So, I bonded the bushings first. But it was not enough, because the cause of the looseness was the internal diameter of bushings. So, I changed the bushings to the ball bearings. |
|
Grease The grease of the oscillation mechanism and the bushings of drive gear is too hard. So, I changed the grease to Shimano's grease (not ACE-2). And it is better that the oil of one-way-clutch is changed to Shimano's reel oil. |
Avocet C is cheap. But it doesn't mean the cheap quality. Its low price
comes from the "made in China". So, the little arrangement make it a useful reel. Especially the rotor brake can be used other reels. |
(2006/5/10)
MITCHELL