Bail arm

I prevent the tangle on the 80's bail arm by this way.

	Line tangle This is a problem of 80's bail arm. A: The right position. B: The line runs on the collar. The line is twisted and makes trouble. C: The line winds on the nut. It cannot wind.
	Measure I make the "line guards" on the bail arm by epoxy resin.(5min type) Take care, the epoxy is harmful.
	Put the resin Remove the bail wire. Put the epoxy resin.
	Form the resin When the resin does not stick to your finger , form the resin by the collar.
	Put the new resin After the first resin has hardened , put the new resin.
	Form the resin Form the resin by the gravity.
	Finish

MITCHELL has left this problem until the end of 300 series. What were you doing !?
Even if MITCHELL had done so , the 300 series had been living until 2001.
If MITCHELL had improved it , the 300 series would be living now.

Oh , my god !

I had found this problem on my first 308A on 1984 already !
Do you employ me ? MITCHELL !
But I had learned "French-1" for 3 years in university !
Oh !
(2003/4/16)

MITCHELL spinning reels