Bushings in knob(Part2)
The bushings of Shimano can be used for MITCHELL's knob.
Shimano's bushings It is used on the main shaft of Shimano's 98 spinning reels of 1000, 2000, 2500. |
|
Tools Drill:4.5,4.8,5.0,6.3 Shimano's bushings: 2 or 3 pieces. |
|
Drill6.3 Make the tip flat by abrasive cloth or grinder. |
|
The handle knob shafts The older type of 60's is made by cut (under). The newer type is made by header (above). The newer type is not straight. |
|
The newer type Some of this type can not be set the bushing under the head. |
|
Making a washer In above case, cut the bushings. It becomes a washer. It is not necessary , if you had a 4*5 washers of brass, stainless steel, POM. |
|
Parts From left to right...Bushing, Knob, Bushing, Washer, Shaft. The two bushings are new. The cut one is used only for washer. |
|
Drilling Drill by from 4.5 to 5.0 by hand. |
|
The hole for the flanges of bushings Make the hole for the flange of bushings by 6.3 drill. |
|
The hole |
|
The opposite side Drill the opposite side carefully. |
|
Finish It does not need glue. |
Be careful so as not to break a knob because the old knob is easy to break.
(2003/4/3)
MITCHELL spinning reels